Knife externally 130x130x60 Premium Line

Knife HMUT0130-9GE6A by CUTMETALL for recycling machines by Untha.

 

Compatibility with machines:

For crushers, shredders, pre-shredders and post-shredders by the producer Untha the knife is ideally fitting.

 

Cutting performance and durability:

The efficiency of the spare part depends largely on the version of the material and cutting geometry.

Comparatively, the W9-variant is softer than the X-option. Additionally, the W9-variation wears also faster. On the other hand, it has the advantage of increased toughness and is also resistant to impurities.

Due to the through-hardening process, there is a consistent hardness from the edge layer to the core. This ensures homogenous wear over the lifetime of the knife.

However, this variant must not be armoured or welded on, as it negatively influences the structure of the spare parts. Consequently, fractures and machine damage are possible.

 

Fastening in the machine:

The knife is mounted external on the cutting device. The other parts of this set can be found under the accessories.

The knife can be used for knives and cutters with a length and width of 130mm. Due to the broad range of shredder models, further configuration variants are possible.

It is imperative that the knife is only affixed to knife holders or knife crossbars with intact supports, as otherwise the attachment may cause breakage.

 

General characteristics:

This knife is 130mm long, 130mm wide and 60mm high.

As this knife belongs to our Premium Line, the component shown comes exclusively from German manufacturing.